Isns-1008; Isns-1009; Isns-1010; Isns-1011 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

ISNS-1008

Message
<timestamp>, [ISNS-1008], <sequence-number>,, INFO, <system-name>, Peering with
external iSNS server <iSNS server IP address> not started because configuration
unchanged.
Probable Cause Indicates that peering with the external iSNS server was already started with the same
configuration.
Recommended No action is required. You may change the configuration and retry the peering with the external
Action iSNS server.
Severity INFO

ISNS-1009

Message
<timestamp>, [ISNS-1009], <sequence-number>,, INFO, <system-name>, Peering with
external iSNS server <iSNS server IP address>not started because no virtual
targets found.
Probable Cause Indicates that no virtual targets were found, so peering was not started.
Recommended No action is required. Peering will resume automatically when virtual targets are detected.
Action
Severity INFO

ISNS-1010

Message
<timestamp>, [ISNS-1010], <sequence-number>,, WARNING, <system-name>, Slot/port
<Slot>/ge<Port> is out of range.
Probable Cause Indicates that the slot or port is out of range.
Recommended Retry with a valid slot/port. Refer to the appropriate hardware reference manual for valid slot and
Action port ranges.
Severity WARNING

ISNS-1011

Message
<timestamp>, [ISNS-1011], <sequence-number>,, INFO, <system-name>, iSNS Client
Service is <iSNS client State (enabled/disabled)>.
Probable Cause Indicates the current state of the internet storage name service (iSNS) Client as enabled or
disabled.
Recommended No action is required. Use the fosConfig command to display, enable, or disable the iSNS Client
Action service.
Fabric OS Message Reference
53-1000437-01
40
ISNS-1008
277