Swch-1001; Swch-1002; Swch-1003; Swch System Messages - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

SWCH System Messages

SWCH-1001

Message
<timestamp>, [SWCH-1001], <sequence-number>,, ERROR, <system-name>, Switch is not
in ready state - Switch enable failed switch status= 0x<switch status>, c_flags =
0x<switch control flags>.
Probable Cause Indicates that the switch is enabled before it is ready.
Recommended If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
Action supportSave command and contact your switch service provider.
Severity ERROR

SWCH-1002

Message
<timestamp>, [SWCH-1002], <sequence-number>,, INFO, <system-name>, Security
violation: Unauthorized device <wwn name of device> tries to flogin to port <port
number>.
Probable Cause Indicates that the device is not present in the authorized profile list.
Recommended Verify that the device is authorized to log in to the switch. If the device is authorized, run the
Action secPolicyDump command to verify whether the specified device world-wide name (WWN) is listed.
If it is not listed, run the secPolicyAdd command to add this device to an existing policy.
Severity INFO

SWCH-1003

Message
<timestamp>, [SWCH-1003], <sequence-number>,, ERROR, <system-name>, Slot ENABLED
but Not Ready during recovery, disabling slot = <slot number>(<return value>).
Probable Cause Indicates that the slot state has been detected as inconsistent during failover or recovery.
Recommended On a Brocade 24000 or 48000 switch, run the slotPowerOff command and then the slotPowerOn
Action command.
On a Brocade 7500 or AP7600 switch, reboot or power cycle the switch.
Severity ERROR
Fabric OS Message Reference
53-1000437-01
Chapter
67
413