Sec-1025; Sec-1026; Sec-1028 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference
Brocade fabric os message reference - supporting fabric os v5.3.0 (53-1000437-01, june 2007)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Reference manual (1240 pages) ,
- Command reference manual (894 pages) ,
- Administrator's manual (452 pages)
Table of Contents
Advertisement
SEC-1025
Message
<timestamp>, [SEC-1025], <sequence-number>,, ERROR, <system-name>, Invalid IP
address
Probable Cause
Indicates that a corruption occurred during the distribution of the security database. This can occur
only when the primary fabric configurations server (FCS) distributes the security database to the
other switches in the fabric, then local validation finds the error in the security database. This is a
rare occurrence.
Recommended
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity
ERROR
SEC-1026
Message
<timestamp>, [SEC-1026], <sequence-number>,, ERROR, <system-name>, Invalid format
or character in switch member
Probable Cause
Indicates that a corruption occurred during the distribution of the security database. This can occur
only when the primary fabric configurations server (FCS) distributes the security database to the
other switches in the fabric, then local validation finds the error in the security database. This is a
rare occurrence.
Recommended
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity
ERROR
SEC-1028
Message
<timestamp>, [SEC-1028], <sequence-number>,, ERROR, <system-name>, No name is
specified.
Probable Cause
Indicates that a corruption occurred during the distribution of the security database. This can occur
only when the primary fabric configurations server (FCS) distributes the security database to the
other switches in the fabric, then local validation finds the error in the security database. This is a
rare occurrence.
Recommended
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity
ERROR
Fabric OS Message Reference
53-1000437-01
(<IP address>)
detected.
<switch member ID>
SEC-1025
.
63
339
Advertisement
Table of Contents
