Sec-1251; Sec-1253; Sec-1300 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

63

SEC-1251

SEC-1251
Message
<timestamp>, [SEC-1251], <sequence-number>,, ERROR, <system-name>, Policy to
binary conversion error: <text message> <value>.
Probable Cause Indicates that the security database conversion failed because of invalid values. The reason is
specified in the text message variable and faulty value is printed in value variable.
Recommended Retry the failed security command.
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR

SEC-1253

Message
<timestamp>, [SEC-1253], <sequence-number>,, ERROR, <system-name>, Bad DCC
interface state during <Phase>, state=<state>.
Probable Cause Indicates that an internal error has caused the device connection control (DCC) policy update to fail
in the provision, commit, or cancel phases.
Recommended Retry the failed security command.
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR

SEC-1300

Message
<timestamp>, [SEC-1300], <sequence-number>,, INFO, <system-name>, This switch is
in VcEncode mode. Security is not supported.
Probable Cause Indicates that the switch is set up with VC-encoded mode.
Recommended Turn off VC-encoded mode before enabling security.
Action
Severity INFO
384 Fabric OS Message Reference
53-1000437-01