ZONE-1040
Message
<timestamp>, [ZONE-1040], <sequence-number>,, INFO, <system-name>, Merged zone
database exceeds limit.
Probable Cause
Indicates that the Fabric OS cannot read the merged zone configuration file. Typically the zone
configuration is too large for the memory available on the switch.
Recommended
Reduce the size of the zone database and retry the operation.
Action
Severity
INFO
ZONE-1041
Message
<timestamp>, [ZONE-1041], <sequence-number>,, WARNING, <system-name>, Unstable
link detected during merge at port (
Probable Cause
Indicates a possible unstable link or faulty cable.
Recommended
Check the SFP and cable at the specified port and verify that they are not faulty. Replace the SFP
Action
and cable as necessary.
Severity
WARNING
ZONE-1042
Message
<timestamp>, [ZONE-1042], <sequence-number>,, INFO, <system-name>, The effective
configuration has been disabled.
Probable Cause
Indicates that the effective zone configuration has been disabled.
Recommended
Verify that this zone configuration change was done on purpose. If no effective zone configuration
Action
is needed, no action is necessary.
Severity
INFO
ZONE-1043
Message
<timestamp>, [ZONE-1043], <sequence-number>,, INFO, <system-name>, The Default
Zone access mode is set to No Access.
Probable Cause
Indicates that the Default Zone access mode is set to No Access.
Recommended
Verify that this Default Zone access mode change was done intentionally.
Action
Severity
INFO
Fabric OS Message Reference
53-1000437-01
<Port number>
).
<AD Id>
.
77
ZONE-1040
455