Sulb-1002; Sulb-1001; Sulb-1003; Audit Sulb System Messages - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

AUDIT SULB System Messages

SULB-1001

Message
AUDIT, <timestamp>, [SULB-1001], WARNING, FIRMWARE, <event-initiator-details>,
<event-location>, , Firmwaredownload command has started.
Probable Cause Indicates that the firmwareDownload command has been entered. This process should take
approximately 17 minutes. The process is set to time out after 30 minutes.
Recommended No action is required. Allow the firmwareDownload command to continue without disruption. Do
Action not fail over or power down the system during firmware upgrade.
Run the firmwareDownloadStatus command for more information.
Severity WARNING

SULB-1002

Message
AUDIT, <timestamp>, [SULB-1002], INFO, FIRMWARE, <event-initiator-details>,
<event-location>, , Firmwaredownload command has completed successfully.
Probable Cause Indicates that the firmwareDownload command has completed successfully and switch firmware
has been updated.
Recommended No action is required. The firmwareDownload command has completed as expected.
Action
Run the firmwareDownloadStatus command for more information. Run firmwareShow to verify the
firmware versions.
Severity INFO

SULB-1003

Message
AUDIT, <timestamp>, [SULB-1003], INFO, FIRMWARE, <event-initiator-details>,
<event-location>, , Firmwarecommit has started.
Probable Cause Indicates that the firmwareCommit command has been entered.
Recommended No action is required. Run the firmwareDownloadStatus command for more information.
Action
Severity INFO
Fabric OS Message Reference
53-1000437-01
Chapter
83
481