Sec-1092; Sec-1093; Sec-1094 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference
Brocade fabric os message reference - supporting fabric os v5.3.0 (53-1000437-01, june 2007)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Reference manual (1240 pages) ,
- Command reference manual (894 pages) ,
- Administrator's manual (452 pages)
Table of Contents
Advertisement
SEC-1092
Message
<timestamp>, [SEC-1092], <sequence-number>,, ERROR, <system-name>,
name>
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity
ERROR
SEC-1093
Message
<timestamp>, [SEC-1093], <sequence-number>,, ERROR, <system-name>, New FCS list
must have at least one member in common with current FCS list.
Probable Cause
Indicates that the new fabric configurations server (FCS) list does not have a common member
with the existing FCS list.
Recommended
Resubmit the command with at least one member of the new FCS list in common with the current
Action
FCS list.
Severity
ERROR
SEC-1094
Message
<timestamp>, [SEC-1094], <sequence-number>,, ERROR, <system-name>, Policy member
not found.
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity
ERROR
Fabric OS Message Reference
53-1000437-01
Name not found.
63
SEC-1092
<Policy
357
Advertisement
Table of Contents
