Sec-1155; Sec-1156; Sec-1157 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

63

SEC-1155

SEC-1155
Message
<timestamp>, [SEC-1155], <sequence-number>,, INFO, <system-name>, PID change
failed: <Reason> <defined status> <active status>.
Probable Cause Indicates that either the defined or active policy was too large after modifying the index/area ID.
The status values can be either defined, active, or both. A negative value means that a policy set
was failed by the daemon.
Recommended Reduce the size of the specified policy database.
Action
Severity INFO

SEC-1156

Message
<timestamp>, [SEC-1156], <sequence-number>,, INFO, <system-name>, Change failed:
<Reason> <defined status> <active status>.
Probable Cause Indicates that the security daemon is busy. The status values can be either defined, active, or both.
A negative value means that a policy set was failed by the daemon.
Recommended For the first reject, wait a few minutes and then resubmit the transaction. Fabric-wide commands
Action might take a few minutes to propagate throughout the fabric. Make sure to wait a few minutes
between executing commands so that your commands do not overlap in the fabric.
Severity INFO

SEC-1157

Message
<timestamp>, [SEC-1157], <sequence-number>,, INFO, <system-name>, PID Change
failed: <Reason> <defined status> <active status>.
Probable Cause Indicates that the provisioning resources for a security policy failed due to low memory or internal
error. The status values can be either defined, active, or both. A negative value means that a policy
set was failed by the daemon.
Recommended Retry the failed command.
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity INFO
370 Fabric OS Message Reference
53-1000437-01