Fcr-1049; Fcr-1053; Fcr-1054 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

FCR-1049

Message
<timestamp>, [FCR-1049], <sequence-number>,, ERROR, <system-name>, EX port (
number>
Probable Cause Indicates an incoming exchange link protocol (ELP) command was issued and it is not supported.
Recommended Run the portEnable and portDisable commands to enable and disable the port.
Action
If the problem persists contact your switch service provider.
Severity ERROR

FCR-1053

Message
<timestamp>, [FCR-1053], <sequence-number>,, WARNING, <system-name>, Port <port
number> was disabled, <disable reason>.
Probable Cause Indicates that the specified port was disabled because of a mismatched configuration parameter.
Recommended Use the specified disable reason to identify a possible configuration parameter mismatch between
Action the EX_Port and the switch at other end of the link.
Severity WARNING

FCR-1054

Message
<timestamp>, [FCR-1054], <sequence-number>,, WARNING, <system-name>, Port <port
number> received ILS <command> of incorrect size (<actual payload size>); valid
ILS size is <expected payload size>.
Probable Cause Indicates that an internal link service (ILS) IU of invalid size was received from the switch on the
other end of the link.
Recommended Check the error message log on the other switch using the errShow command for additional
Action messages.
Check for a faulty cable or deteriorated small form-factor pluggable (SFP). Replace the cable or SFP
if necessary.
Run the portLogDumpPort command on both the receiving and transmitting port.
Run the fabStateShow command on transmitting switch.
If the message persists, collect switch information using the supportShow command, and contact
your switch service provider.
Severity WARNING
Fabric OS Message Reference
53-1000437-01
) received an ELP command that is not supported.
20
FCR-1049
<port
129