Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference page 454

66
SULB-1009
Table 8
firmwareDownload process the error occurred.
TABLE 8
Upgrade State
SUS_PEER_CHECK_SANITY
SUS_PEER_FWDL_BEGIN
SUS_SBY_FWDL_BEGIN
SUS_PEER_REBOOT
SUS_SBY_REBOOT
SUS_SBY_FABOS_OK
SUS_PEER_FS_CHECK
SUS_SELF_FAILOVER
SUS_SBY_FWDL1_BEGIN
SUS_SELF_FWDL_BEGIN
SUS_SELF_COMMIT
SUS_SBY_FWC_BEGIN
SUS_SBY_COMMIT
SUS_SBY_FS_CHECK
SUS_ACT_FWC_BEGIN
SUS_PEER_RESTORE_BEGIN
SUS_SBY_RESTORE_BEGIN
SUS_PEER_FWC_BEGIN
SUS_PEER_FS_CHECK1
SUS_FINISH
SUS_COMMIT
Recommended Run the firmwareDownloadStatus command for more information.
Action
In a director-class switch, when firmwareDownload fails, the command will synchronize the
firmware on the two partitions of each CP by starting a firmware commit operation. Wait until this
operation completes (about 10 minutes) before attempting another firmwareDownload.
In a director-class switch, when firmwareDownload fails, the two CPs may end up with different
versions of firmware and they may not gain high-availability (HA) sync. In that case, run
firmwareDownload single mode (-s) to upgrade the firmware on the standby CP to the same version
as the active CP. Then retry firmwareDownload to download the desired version of firmware onto
the CPs.
Refer to the Fabric OS Administrator's Guide for troubleshooting information.
Severity INFO
406
lists the firmwareDownload state names and state values. They indicate where in the
Upgrade State and Code Value
Code
0x21
0x22
0x23
0x24
0x25
0x26
0x27
0x28
0x29
0x2a
0x2b
0x2c
0x2d
0x2e
0x2f
0x30
0x31
0x32
0x33
0x34
0x35
Fabric OS Message Reference
53-1000437-01