ZONE-1006
Message
<timestamp>, [ZONE-1006], <sequence-number>,, WARNING, <system-name>, WARNING -
WWN(<WWN number>) in HARD PORT zone <zone_name>.
Probable Cause
Indicates that one or more devices are zoned as world-wide name (WWN) devices and also zoned
as <domain, portarea> devices. The device(s) are used to specify zone members over separate
zones.
Recommended
If hardware zoning enforcement is preferred, edit the zoning database to have the device zoned
Action
using only one specification type, either WWN or <domain, portarea>.
Severity
WARNING
ZONE-1007
Message
<timestamp>, [ZONE-1007], <sequence-number>,, INFO, <system-name>,
Ioctl(<function>) in (<error message>) at port (<port number>) returns code
(<error string>) and reason string (<reason string>).
Probable Cause
Indicates that frame filter logic reported a failure during one of the IOCTL calls. The IOCTL call from
which the failure is reported is listed as part of the error message. This is usually a programming
error when adding content-addressable memory (CAM) entries before the filter setup.
Recommended
There are two ways to avoid this problem.
Action
•
•
Severity
INFO
ZONE-1008
Message
<timestamp>, [ZONE-1008], <sequence-number>,, WARNING, <system-name>, WARNING -
port
Probable Cause
Indicates that the total number of entries of S_ID CAM is above the limit while creating or adding a
zone group. The maximum number of content-addressable memory (CAM) entries allowed depends
on the application-specific integrated circuit (ASIC).
Recommended
If hardware zoning enforcement is preferred, edit the zoning database to have zoned PIDs for that
Action
port.
Severity
WARNING
Fabric OS Message Reference
53-1000437-01
Avoid having too many hosts zoned with a set of target devices at a single port.
Avoid having too many zones directed at a single port group on the switch.
<port number>
Out of CAM entries.
77
ZONE-1006
445