Sec-1098; Sec-1099; Sec-1100 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

SEC-1098

Message
<timestamp>, [SEC-1098], <sequence-number>,, ERROR, <system-name>, No
defined>
Probable Cause Indicates that the specified policy could not be found.
Recommended Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave
Action command and contact your switch service provider.
Severity ERROR

SEC-1099

Message
<timestamp>, [SEC-1099], <sequence-number>,, ERROR, <system-name>, Please enable
your switch before running secModeEnable.
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR

SEC-1100

Message
<timestamp>, [SEC-1100], <sequence-number>,, ERROR, <system-name>, FCS switch
present. Command terminated.
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
Fabric OS Message Reference
53-1000437-01
FCS list.
63
SEC-1098
<active or
359