Fcr-1021; Fcr-1022; Fcr-1023 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

20

FCR-1021

To do that, perform the following steps:
1. Run portDisable to disable all the EX_Ports that got this error message.
2. Run portDisable to disable all the other EX_Ports on that FCR connected to the same edge
3. Use Zoning commands on the edge fabrics, to reduce the LSAN zone entries on the edge
4. Run portEnable on each EX_Port, one at a time, to reenable the EX_Ports, and verify that this
Severity WARNING
FCR-1021
Message
<timestamp>, [FCR-1021], <sequence-number>,, WARNING, <system-name>, Local LSAN
device entries exhausted.
Probable Cause Indicates that the number of devices created through logical storage area network (LSAN) zones
within the MetaSAN exceeds the local LSAN zone database limitations.
Recommended Remove excess device entries within LSAN zones so that the number of devices is within the range
Action of the local zone database limitations.
Severity WARNING

FCR-1022

Message
<timestamp>, [FCR-1022], <sequence-number>,, ERROR, <system-name>, Local proxy
device slot entries exhausted.
Probable Cause Indicates that the resources used to persistently store the proxy device slot to the remote
world-wide name (WWN) have been consumed.
Recommended Remove the proxy device slots by using the fcrProxyConfig command or limit proxy devices by
Action removing logical storage area network (LSAN) zone entries.
Severity ERROR

FCR-1023

Message
<timestamp>, [FCR-1023], <sequence-number>,, WARNING, <system-name>, Local
phantom port WWN entries exhausted.
Probable Cause Indicates that the number of port world-wide names (WWNs) in use exceeds the local port WWN
resources.
122
fabrics the EX_ports disabled in step 1 are connected to.
fabrics.
error is not reported again.
Fabric OS Message Reference
53-1000437-01