Sec-1054; Sec-1055; Sec-1056 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

SEC-1054

Message
<timestamp>, [SEC-1054], <sequence-number>,, ERROR, <system-name>, Invalid FCS
list length
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR

SEC-1055

Message
<timestamp>, [SEC-1055], <sequence-number>,, ERROR, <system-name>, Invalid FCS
list
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR

SEC-1056

Message
<timestamp>, [SEC-1056], <sequence-number>,, ERROR, <system-name>, Invalid
position <New position>. Only <Number of members in FCS list> members in list.
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
Fabric OS Message Reference
53-1000437-01
<list length>
<WWN list>
63
SEC-1054
347