Sec-1311; Sec-1312; Sec-1313 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

63

SEC-1311

Severity INFO
SEC-1311
Message
<timestamp>, [SEC-1311], <sequence-number>,, ERROR, <system-name>, Security mode
cannot be enabled because one or more of the password policies is not set to
default value.
Probable Cause Indicates that the security enable failed on the fabric because one or more switches in the fabric
have password policies that are not set to the default value.
Recommended Verify that the security event was planned.
Action
If the security event was planned, run the passwdCfg --setDefault command on each switch in the
fabric to set the password policies to the default value. Then verify with passwdCfg --show that
password policies are set to the default values on all switches and retry the secModeEnable
command.
Severity ERROR

SEC-1312

Message
<timestamp>, [SEC-1312], <sequence-number>,, INFO, <system-name>,
Message>
Probable Cause Indicates that the passwdCfg parameters changed.
Recommended Verify that the security event was planned. If the security event was planned, no action is required.
Action If the security event was not planned, take appropriate action as defined by your enterprise
security policy.
Severity INFO

SEC-1313

Message
<timestamp>, [SEC-1313], <sequence-number>,, INFO, <system-name>, The passwdcfg
parameters were set to default values.
Probable Cause Indicates that the passwdCfg parameters were set to default values.
Recommended Verify that the security event was planned. If the security event was planned, no action is required.
Action If the security event was not planned, take appropriate action as defined by your enterprise
security policy.
Severity INFO
388
.
<MESG
Fabric OS Message Reference
53-1000437-01