Sec-1080; Sec-1081; Sec-1082 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

SEC-1080

Message
<timestamp>, [SEC-1080], <sequence-number>,, ERROR, <system-name>, Operation
denied. Please, use secModeEnable command.
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR

SEC-1081

Message
<timestamp>, [SEC-1081], <sequence-number>,, ERROR, <system-name>, Entered a name
for a DCC policy ID that was not unique.
Probable Cause Indicates that the device connection control (DCC) policy name given in the secPolicyCreate
command was the same as another DCC policy.
Recommended Make sure that the DCC policy name has a unique alpha-numeric string, and run the
Action secPolicyCreate command again.
Severity ERROR

SEC-1082

Message
<timestamp>, [SEC-1082], <sequence-number>,, ERROR, <system-name>, Failed to
create
Probable Cause Indicates that the security policy was not created due to faulty input or low resources.
Recommended Use proper syntax when creating policies. If the security database is too large, you must delete
Action other members within the database before adding new members to a policy.
Severity ERROR
Fabric OS Message Reference
53-1000437-01
<policy name>
policy.
63
SEC-1080
353