SEC-1086
Message
<timestamp>, [SEC-1086], <sequence-number>,, ERROR, <system-name>, The security
database is too large to fit in flash.
Probable Cause
Indicates that the security database has more data than the flash can accommodate.
Recommended
Reduce the number of entries in some policies to decrease the security database size.
Action
Severity
ERROR
SEC-1087
Message
<timestamp>, [SEC-1087], <sequence-number>,, ERROR, <system-name>, The security
database is larger than the data distribution limit of fabric
distribution limit>
Probable Cause
Indicates that the security database has more data than can be distributed to some of the switches
in the fabric.
Recommended
Reduce the number of entries in the security policies to decrease the security database size.
Action
Severity
ERROR
SEC-1088
Message
<timestamp>, [SEC-1088], <sequence-number>,, ERROR, <system-name>, Cannot execute
the command. Please try later.
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity
ERROR
Fabric OS Message Reference
53-1000437-01
bytes.
63
SEC-1086
<fabric data
355