Webd-1001; Webd-1002; Webd-1003; Webd System Messages - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

WEBD System Messages

WEBD-1001

Message
<timestamp>, [WEBD-1001], <sequence-number>,, WARNING, <system-name>, Missing or
Invalid Certificate file -- HTTPS is configured to be enabled but could not be
started.
Probable Cause Indicates that the SSL certificate file is either invalid or absent.
Recommended Run the configure command to disable HTTPS. Install a valid key file and enable HTTPS again. For
Action more information on the configure command, refer to the Fabric OS Command Reference.
Severity WARNING

WEBD-1002

Message
<timestamp>, [WEBD-1002], <sequence-number>,, WARNING, <system-name>, Missing or
Invalid Key file -- HTTPS is configured to be enabled but could not be started.
Probable Cause Indicates that the SSL key file is either invalid or absent.
Recommended Run the configure command to disable HTTPS. Install a valid key file and enable HTTPS again. For
Action more information on the configure command, refer to the Fabric OS Command Reference.
Severity WARNING

WEBD-1003

Message
<timestamp>, [WEBD-1003], <sequence-number>,, INFO, <system-name>, HTTP/HTTPS
interface disabled
Probable Cause Indicates that the HTTP/HTTPS interface is disabled. This is logged when HTTP/HTTPS is disabled
through the configure command.
Recommended Run the configure command to enable HTTP/HTTPS. For more information on the configure
Action command, refer to the Fabric OS Command Reference.
Severity INFO
Fabric OS Message Reference
53-1000437-01
Chapter
75
437