Sulb-1026; Sulb-1030; Sulb-1031; Sulb-1033 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

66

SULB-1026

SULB-1026
Message
<timestamp>, [SULB-1026], <sequence-number>, AUDIT, WARNING, <system-name>,
Firmware commit operation started on the blade in slot
Probable Cause firmwareCommit has started on the specified blade. The operation may be a normal part of
firmwareDownload, or it may have started to repair the secondary partition of the blade if the
secondary partition is corrupted.
Recommended No action is required.
Action
Severity WARNING

SULB-1030

Message
<timestamp>, [SULB-1030], AUDIT, WARNING, <system-name>, The switch has rebooted
during relocating the internal firmware image.
Probable Cause The error may be caused by an unexpected disruption of the firmwareDownload command, for
example, by powering the switch off and on in the middle of a firmwareDownload. The error may
also be caused by persistent storage hardware failure or by a software error.
Recommended firmwareDownload will continue after the switch has rebooted. Run the firmwareDownloadStatus
Action command to monitor progress. If the problem persists, contact your switch service provider.
Severity WARNING

SULB-1031

Message
<timestamp>, [SULB-1031], <sequence-number>, AUDIT, WARNING, <system-name>, The
switch is relocating an internal firmware image.
Probable Cause Indicates that the switch has rebooted with the new firmware and is relocating the AP firmware.
Recommended Wait for the operation to complete.
Action
Severity WARNING

SULB-1033

Message
<timestamp>, [SULB-1033], <sequence-number>, AUDIT, WARNING, <system-name>,
Switch has completed relocating the internal firmware image.
Probable Cause Indicates that the firmwareDownload process has completed normally on the switch.
Recommended Run the firmwareShow command to verify the firmware versions. Run the switchShow command to
Action make sure the switch is enabled.
410
<Slot number> .
Fabric OS Message Reference
53-1000437-01