Fssm-1002; Fssm-1003; Fssm System Messages - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

FSSM System Messages

FSSM-1002

Message
<timestamp>, [FSSM-1002], <sequence-number>,, INFO, <system-name>, HA State is in
sync.
Probable Cause Indicates that the high availability (HA) state for the active control processor (CP) is in
synchronization with the HA state of the standby CP. If the standby CP is healthy, then a failover is
nondisruptive. For more information on the haFailover command, refer to the Fabric OS Command
Reference.
Recommended No action is required.
Action
Severity INFO

FSSM-1003

Message
<timestamp>, [FSSM-1003], <sequence-number>,, WARNING, <system-name>, HA State
out of sync.
Probable Cause Indicates that the high availability (HA) state for the active control processor (CP) is out of
synchronization with the HA state of the standby CP. If the active CP failover occurs when the HA
state is out of sync, the failover is disruptive.
Recommended If this message was logged as a result of a user-initiated action (such as running the switchReboot
Action command), then no action is required.
Otherwise, issue the haSyncStart command on the active CP and try resynchronizing the HA state.
If the HA state does not become synchronized, run the haDump command to diagnose the
problem.
If the problem persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
Fabric OS Message Reference
53-1000437-01
Chapter
26
153