Sulb-1021; Sulb-1023; Sulb-1024 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

Probable Cause The BP blade should reboot with the new image, but is still running the old image. This error may
indicate that the new image has not been loaded correctly to the specified blade.
Recommended Run the slotShow command. If the blade is in a FAULTY state, run the slotPowerOff and
Action slotPowerOn commands to trigger another firmwareDownload to the blade. If the blade is stuck in
LOADING state, remove and re-insert the blade to trigger another firmwareDownload. If the
problem persists, contact your switch service provider.
Severity ERROR

SULB-1021

Message
AUDIT, <timestamp>, [SULB-1021], WARNING, FIRMWARE, <event-initiator-details>,
<event-location>, , Firmware is being downloaded to the blade in slot
number>.
Probable Cause Indicates that the firmware is being loaded to the specified blade.
Recommended Run the firmwareDownloadStatus command to monitor the firmwareDownload progress. After it
Action finishes, run the firmwareShow command to verify the firmware versions.
Severity WARNING

SULB-1023

Message
AUDIT, <timestamp>, [SULB-1023], WARNING, FIRMWARE, <event-initiator-details>,
<event-location>, , The blade in slot
firmwaredownload.
Probable Cause The error may be caused by an unexpected disruption of the firmwareDownload command, for
example, by powering off and on of the indicated BP blade in the middle of a firmwareDownload.
The error may also be caused by persistent storage hardware failure or by a software error.
Recommended firmwareCommit will be started automatically after the blade boots up to repair the secondary
Action partition. If at the end of firmwareCommit, the blade firmware version is still inconsistent with the
active CP firmware, firmwareDownload will automatically be restarted on the blade. Run the
firmwareDownloadStatus command to monitor the progress. If the problem persists, contact your
switch service provider.
Severity WARNING

SULB-1024

Message
AUDIT, <timestamp>, [SULB-1024], WARNING, FIRMWARE, <event-initiator-details>,
<event-location>, , Firmware commit has completed on the blade in slot
number>.
Probable Cause Indicates that the firmwareCommit operation has completed on the specified blade.
Fabric OS Message Reference
53-1000437-01
<Slot number>
has rebooted during
83
SULB-1021
<Slot
<Slot
489