Fw-1165; Fw-1166; Fw-1167 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference
Brocade fabric os message reference - supporting fabric os v5.3.0 (53-1000437-01, june 2007)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Reference manual (1240 pages) ,
- Command reference manual (894 pages) ,
- Administrator's manual (452 pages)
Table of Contents
Advertisement
27
FW-1165
Severity
INFO
FW-1165
Message
<timestamp>, [FW-1165], <sequence-number>,, INFO, <system-name>, <Port Name>,
<Label>, is below low boundary(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause
Indicates that the number of synchronization losses that the port experiences has fallen below the
low boundary. Loss of synchronization errors frequently occur due to a faulty small form-factor
pluggable (SFP) or cable. Signal losses often create synchronization losses.
Recommended
No action is required. Respond to this message as is appropriate to the particular policy of the
Action
end-user installation. A low number of synchronization losses means that the switch is functioning
normally.
Severity
INFO
FW-1166
Message
<timestamp>, [FW-1166], <sequence-number>,, WARNING, <system-name>, <Port Name>,
<Label>, is above high boundary(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause
Indicates that the number of synchronization losses that the port experiences has risen above the
high boundary. Loss-of-synchronization errors frequently occur due to a faulty small form-factor
pluggable (SFP) or cable. Signal losses often create synchronization losses.
Recommended
Check both ends of your cable connection. Verify that the cable and small form-factor pluggables
Action
(SFPs) are not faulty.
If you continue to experience loss-of-synchronization errors, troubleshoot your host bus adaptor
(HBA) and contact your switch service provider.
Severity
WARNING
FW-1167
Message
<timestamp>, [FW-1167], <sequence-number>,, INFO, <system-name>, <Port Name>,
<Label>, is between high and low boundaries(High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.
Probable Cause
Indicates that the number of synchronization losses that the port experiences has changed from a
value outside of the acceptable range to a value within the acceptable range. Loss of
synchronization errors frequently occur due to a faulty small form-factor pluggable (SFP) or cable.
Signal losses often create synchronization losses.
Recommended
No action is required. Respond to this message as is appropriate to the particular policy of the
Action
end-user installation.
Severity
INFO
178
Fabric OS Message Reference
53-1000437-01
Advertisement
Table of Contents
