Sec-1101; Sec-1102; Sec-1104 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

63

SEC-1101

SEC-1101
Message
<timestamp>, [SEC-1101], <sequence-number>,, ERROR, <system-name>, Failed to
enable security on all switches. Please retry later.
Probable Cause Indicates that the security enable failed on the fabric because one or more switches in the fabric
are busy.
Recommended Verify that the security event was planned. If the security event was planned, run the
Action secFabricShow command to verify that all switches in the fabric are in the ready state. When all
switches are in the ready state, retry the operation.
Severity ERROR

SEC-1102

Message
<timestamp>, [SEC-1102], <sequence-number>,, ERROR, <system-name>, Fail to
download
Probable Cause Indicates that the switch failed to download certificate, security database, or policies. This can
happen when switch does not get enough resources to complete the operation, fabric has not
stabilized, or policy database is an invalid format.
Recommended Wait for fabric to become stable and then retry the operation. If the policy database is in an illegal
Action format (with configDownload), correct the format and retry the operation.
Severity ERROR

SEC-1104

Message
<timestamp>, [SEC-1104], <sequence-number>,, ERROR, <system-name>, Fail to get
primary
Probable Cause Indicates that the switch failed to get either the primary certificate or a primary public key.
Recommended Verify that the primary switch has a valid certificate installed and retry the operation. If a valid
Action certificate is not installed, install a certificate by following the procedure specified in the Secure
Fabric OS Administrator's Guide.
Severity ERROR
360
<security data>
.
<Certificate or public key>
.
Fabric OS Message Reference
53-1000437-01