Fcr-1062; Fcr-1063; Fcr-1064; Fcr-1065 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

20

FCR-1062

Recommended No action is required.
Action
Severity INFO
FCR-1062
Message
<timestamp>, [FCR-1062], <sequence-number>,, INFO, <system-name>, Port <port
number> disabled, system only supports <maximum ports> EX/VEX_ports.
Probable Cause Indicates that the maximum number of supported EX_ports or VEX_ports was exceeded. To enable
the specified port, disable any other operational port then re-enable the port.
Recommended No action is required.
Action
Severity INFO

FCR-1063

Message
<timestamp>, [FCR-1063], <sequence-number>,, INFO, <system-name>, Fabric <fabric
ID> for switch with domain ID: <domain ID> mismatch with local fabric ID <local
fabric ID>.
Probable Cause Indicates that the fabric ID of the switch does not match the local switch.
Recommended Run the switchShow command to display the fabric ID. Change the fabric ID to match on both ends
Action by modifying either the local or remote host using the fcrConfigure command.
Severity INFO

FCR-1064

Message
<timestamp>, [FCR-1064], <sequence-number>,, ERROR, <system-name>, Fabric ID of
backbone FC-Routers mismatch or overlap.
Probable Cause Indicates that either (1) a backbone fabric split and both are connected to common edge fabrics,
or (2) the fabric IDs of two backbone fabrics connected to an edge fabric are the same.
Recommended If the backbone fabric split, merge the fabrics.
Action
If two (or more) backbone fabrics have the same IDs, make the fabric IDs unique using
fcrConfigure command.
Severity ERROR

FCR-1065

Message
<timestamp>, [FCR-1065], <sequence-number>,, ERROR, <system-name>, Fabric on port
<port number>
132
was assigned two different fabric IDs.
Fabric OS Message Reference
53-1000437-01