Pdm-1022; Pdm-1023; Pdm-1024 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

51

PDM-1022

Probable Cause Indicates that a system call failed.
Recommended Run the firmwareDownload command to reinstall the firmware.
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
PDM-1022
Message
<timestamp>, [PDM-1022], <sequence-number>,, WARNING, <system-name>, The switch
is configured only with IPv6.
Probable Cause Indicates that the parity data manager (PDM) cannot sync with its peer because the firmware does
not support IPv6.
Recommended Configure the local switch with IPv4 addresses.
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING

PDM-1023

Message
<timestamp>, [PDM-1023], <sequence-number>,, WARNING, <system-name>, Radius is
configured for IPv6.
Probable Cause Indicates that the parity data manager (PDM) cannot sync with its peer because the Radius server
is configured for IPv6 addresses. IPv6 is not supported by older firmware.
Recommended Configure the Radius with IPv4 addresses.
Action
Severity WARNING

PDM-1024

Message
<timestamp>, [PDM-1021], <sequence-number>,, WARNING, <system-name>, DNS is
configured for IPv6.
Probable Cause Indicates that the parity data manager (PDM) cannot sync with its peer because the domain name
service (DNS) is configured for IPv6. IPv6 is not supported by older firmware.
Recommended Run the firmwareDownload command to reinstall the firmware.
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
308 Fabric OS Message Reference
53-1000437-01