Sec-1046; Sec-1049; Sec-1050 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

SEC-1046

Message
<timestamp>, [SEC-1046], <sequence-number>,, ERROR, <system-name>, Empty list.
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR

SEC-1049

Message
<timestamp>, [SEC-1049], <sequence-number>,, ERROR, <system-name>, Invalid switch
name
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR

SEC-1050

Message
<timestamp>, [SEC-1050], <sequence-number>,, ERROR, <system-name>, There are more
than one switches with the same name
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
Fabric OS Message Reference
53-1000437-01
<switch name>
.
<switch name>
in the fabric.
63
SEC-1046
345