Sec-1057; Sec-1059; Sec-1062 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference

63

SEC-1057

SEC-1057
Message
<timestamp>, [SEC-1057], <sequence-number>,, ERROR, <system-name>, No change.
Both positions are the same.
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR

SEC-1059

Message
<timestamp>, [SEC-1059], <sequence-number>,, ERROR, <system-name>, Fail to
<operation, e.g., save, delete, etc.,> <named item> to flash.
Probable Cause Indicates that the operation failed when writing to flash.
Recommended Run the supportFtp - e command to FTP files from the switch and remove them from the flash.
Action
Severity ERROR

SEC-1062

Message
<timestamp>, [SEC-1062], <sequence-number>,, ERROR, <system-name>, Invalid number
of Domains in Domain List.
Probable Cause Indicates either that no domains or domains more than the maximum number supported are
specified.
Recommended Enter the correct number of domains.
Action
Severity ERROR
348 Fabric OS Message Reference
53-1000437-01