Sulb-1001; Sulb-1002; Sulb-1003; Sulb System Messages - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

SULB System Messages

SULB-1001

Message
<timestamp>, [SULB-1001], <sequence-number>, AUDIT, WARNING, <system-name>,
Firmwaredownload command has started.
Probable Cause Indicates the firmwareDownload command has been entered. This process should take
approximately 17 minutes. The process is set to time out after 30 minutes.
Recommended Do not fail over or power down the system during firmware upgrade. Allow the firmwareDownload
Action command to continue without disruption. Do not fail over or power down the system during
firmware upgrade. No action is required.
Run the firmwareDownloadStatus command for more information.
Severity WARNING

SULB-1002

Message
<timestamp>, [SULB-1002],<sequence-number>, AUDIT, INFO, <system-name>,
Firmwaredownload command has completed successfully.
Probable Cause Indicates the firmwareDownload command has completed successfully and switch firmware has
been updated.
Recommended No action is required. The firmwareDownload command has completed as expected.
Action
Run the firmwareDownloadStatus command for more information. Run the firmwareShow
command to verify the firmware versions.
Severity INFO

SULB-1003

Message
<timestamp>, [SULB-1003], <sequence-number>, AUDIT, INFO, <system-name>,
Firmwarecommit has started.
Probable Cause Indicates that the firmwareCommit command has been entered.
Recommended No action is required. Run the firmwareDownloadStatus command for more information.
Action
Severity INFO
Fabric OS Message Reference
53-1001157-01
Chapter
80
487