Sulb-1025; Sulb-1026; Sulb-1030; Sulb-1031 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

80

SULB-1025

SULB-1025
Message
<timestamp>, [SULB-1025], <sequence-number>,, WARNING, <system-name>, The blade
in slot <Slot number> will reboot with the new firmware.
Probable Cause Indicates new firmware has been downloaded to the specified AP blade and that the AP blade will
reboot to activate it.
Recommended Wait for the blade to reboot.
Action
Severity WARNING

SULB-1026

Message
<timestamp>, [SULB-1026], <sequence-number>, AUDIT, WARNING, <system-name>,
Firmware commit operation started on the blade in slot <Slot number>.
Probable Cause Indicates the firmwareCommit has started on the specified blade. The operation may be a normal
part of firmwareDownload, or it may have started to repair the secondary partition of the blade if
the secondary partition is corrupted.
Recommended No action is required.
Action
Severity WARNING

SULB-1030

Message
<timestamp>, [SULB-1030], AUDIT, WARNING, <system-name>, The switch has rebooted
during relocating the internal firmware image.
Probable Cause Indicates there may be an error caused by an unexpected disruption of the firmwareDownload
command, for example, by powering the switch off and on in the middle of a firmwareDownload.
The error may also be caused by persistent storage hardware failure or by a software error.
Recommended The firmwareDownload command will continue after the switch has rebooted. Run the
Action firmwareDownloadStatus command to monitor progress. If the problem persists, contact your
switch service provider.
Severity WARNING

SULB-1031

Message
<timestamp>, [SULB-1031], <sequence-number>, AUDIT, WARNING, <system-name>, The
switch is relocating an internal firmware image.
Probable Cause Indicates the switch has rebooted with the new firmware and is relocating the AP firmware.
498 Fabric OS Message Reference
53-1001157-01