Sec-1097; Sec-1098; Sec-1099; Sec-1100 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

75

SEC-1097

Severity ERROR
SEC-1097
Message
<timestamp>, [SEC-1097], <sequence-number>,, ERROR, <system-name>, Cannot find
<active or defined> policy set.
Probable Cause Indicates the specified policy could not be found.
Recommended If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
Action supportSave command and contact your switch service provider.
Severity ERROR

SEC-1098

Message
<timestamp>, [SEC-1098], <sequence-number>,, ERROR, <system-name>, No <active or
defined> FCS list.
Probable Cause Indicates the specified policy could not be found.
Recommended Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command
Action and contact your switch service provider.
Severity ERROR

SEC-1099

Message
<timestamp>, [SEC-1099], <sequence-number>,, ERROR, <system-name>, Please enable
your switch before running secModeEnable.
Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only
occur when the primary fabric configuration server (FCS) is distributing the security database to the
other switches in the fabric and local validation finds that there is an error in the security database.
This is a rare occurrence.
Recommended Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
Action be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR

SEC-1100

Message
<timestamp>, [SEC-1100], <sequence-number>,, ERROR, <system-name>, FCS switch
present. Command terminated.
430 Fabric OS Message Reference
53-1001157-01