Ms-1009; Ms-1021; Ms-1022 - Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Reference Manual

58

MS-1009

MS-1009
Message
<timestamp>, [MS-1009], <sequence-number>,, ERROR, <system-name>, RLIR event.
Switch Port ID is <PID> (<PID (hex)>). Device Port Tag is <port tag>. <message
text>.
Probable Cause Indicates a registered link incident record (RLIR) has been generated for one of the actions
indicated by the <message>.
The following messages will be displayed:
•
•
•
•
•
Recommended Persistent RLIR incidents are likely the result of SAN hardware problems such as bad cables or
Action small form-factor pluggables (SFPs). It may be necessary to replace hardware if these messages
persist.
Severity ERROR

MS-1021

Message
<timestamp>, [MS-1021], <sequence-number>,, ERROR, <system-name>, MS WARMBOOT
failure(FSS_MS_WARMINIT failed. Reason=<failure reason>).
Probable Cause Indicates the Fabric OS state synchronization (FSS) warm recovery failed during the WARM INIT
phase of a reboot.
Recommended If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
Action supportSave command and contact your switch service provider.
Severity ERROR

MS-1022

Message
<timestamp>, [MS-1022], <sequence-number>,, INFO, <system-name>, Management
Server Platform Service <Activated or Deactivated>.
Probable Cause Indicates Management Server Platform Service is being activated or deactivated.
Recommended No action is required.
Action
Severity INFO
362
Exceeded bit error rate threshold
Loss of signal or synchronization
Not operational seq. recognized
Primitive sequence timeout
Unrecognized link incident
Fabric OS Message Reference
53-1001157-01