Novell NETWARE 6-DOCUMENTATION Manual page 2460

Protocol Parameters
Using BIND
22
Utilities Reference
Protocol/Parameter
For IPX protocol:
NET=number
For other protocols:
Refer to the documentation
that comes with the protocol.
Or, consult the Novell
Support Connection TM
site (http://
support.novell.com) or your
Novell Authorized
Reseller SM representative.
You may not need to use the BIND command unless you want to add new
LAN drivers after the initial server installation.
You can also use INETCFG to load and bind LAN drivers. INETCFG
places the BIND statements in the initsys.cfg file.
If you use only the IPX/SPX
to the AUTOEXEC.NCF file.
Use to
Specify the IPX
This is the number of the cabling system
attached to the board.
If the board is attached to an existing cabling
system, use the same IPX external network
number as used by other boards of the same
frame type attached to this cabling system. Do
not use the same number that was used by
boards of a different frame type.
If the board is attached to a new cabling
system or if it is the first board of its frame type
attached to the cabling system, you can enter
any hexadecimal number of up to eight digits,
as long as the number is different from all other
network numbers.
Remember that all boards of the same frame
type attached to the same cabling system must
use the same IPX external network number for
that cabling system.
Specify the information required by the
particular protocol.
®
Web
protocol, you can add the BIND statement
TM
TM external network number.