Novell NETWARE 6-DOCUMENTATION Manual page 2426

Viewing and Managing Programs in Protected Memory and Protected
Address Spaces
To view and manage programs in protected memory and protected address
spaces, access the Address Space Information page by clicking the Protected
Memory link in the navigation frame.
From the Address Space Information page, you can do the following:
Execute an NCF to load several modules into the same protected address
space
To do this, click the Load Modules Protected button. If you want to see
the System Console screen while the NLM program is loading, check the
Display System Console for NCF Execution check box.
Load an individual module into the protected address space
To do this, click the Load Modules Protected button. If you want to see
the System Console screen while the NLM program is loading, check the
Display System Console for Module Load check box.
View information about an address, such as its name, address space, time
since last fault, restart count, and the status for Restartable, Unload,
Remove, and Restart
If there is a button rather than n/a status in these columns, you can do the
following:
Restartable allows you to change the restart state of that address
space.
Unload unloads all modules from the address space.
Remove removes the address space from the server without running
the termination code of modules in that address space.
Restart allows you to reload that address space.
View information about modules running in protected address spaces on
the server
To view a listing of all NLM programs loaded in the protected address
space, click the name link for that address space.
View or change the current memory protection SET parameter settings
To view the settings, click the Memory Protection Set Parameter link to
display the Memory page.
To change a setting, access the Memory page, click the value link for the
setting, enter a new value within the specified range, and then click OK.
Managing Servers Remotely
53