Novell NETWARE 6-DOCUMENTATION Manual page 2459

Driver Parameters
Depending on your system, one or more of the following parameters can be
used to identify a particular board.
Parameter
DMA=number
FRAME=number
INT=number
MEM=number
PORT=number
SLOT=number
NODE=number
Use to
Specify the DMA channel for the board. Use
the same channel number you did when you
loaded the driver.
Specify the frame type for the board. Use the
same type you did when you loaded the driver.
Specify the interrupt number for the board. Use
the same interrupt number you did when you
loaded the driver.
Specify the memory address for the board. Use
the same memory address you did when you
loaded the driver.
Specify the I/O port for the board. Use the
same I/O port number you did when you
loaded the driver.
Specify the network board by the lot it was
installed in. Use this parameter with
microchannel and EISA computers. Specify
the same slot number you used when you
loaded the driver.
Specify the node address for the board. This is
a 12-digit hexadecimal number.
21
Utilities