Disable Surelink - Digi IX20W-PR User Manual

Interfaces
(config)> network interface my_wan surelink advanced delayed_start
value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set delayed_start to ten minutes, enter either 10m or 600s:
(config)> network interface my_wan surelink advanced delayed_start
600s
(config)>
The default is 300s.
g. Set the time to add to the test interval when restarting the list of actions. This option is
capped at 15 minutes.
(config)> network interface my_wan surelink advanced backoff_interval
value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set backoff_interval to ten minutes, enter either 10m or 600s:
(config)> network interface my_wan surelink advanced backoff_interval
600s
(config)>
The default is 300 seconds.
h. The interface_gateway parameter is used by the Interface gateway Ping test as the
endpoint for traceroute to use to determine the interface gateway. The default is 8.8.8.8,
and should only be changed if this IP address is not accessible due to networking issues.
To set to an alternate host:
(config)> network interface my_wan surelink advanced interface_gateway
hostname/IP_address
(config)>
8. Save the configuration and apply the change
(config network interface my_wan ipv4 surelink)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Disable SureLink

If your device uses a private APN with no Internet access or has a restricted WAN connection that
doesn't allow DNS resolution, you can disable SureLink connectivity tests. You can also reconfigure
IX20 User Guide
Wide Area Networks (WANs)
116