Services
messages. It also affects actions that occur at a specific time of day.
Format:
Africa/Abidjan
Africa/Accra
Africa/Addis_Ababa
...
(config)>
7. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show status and statistics of the NTP server
You can display status and statistics for active NTP servers
WebUI
1. Log into the TX54 WebUI as a user with Admin access.
2. On the main menu, click Status.
3. Under Services, click NTP.
The NTP server status page is displayed.
Command line
Show NTP information
1. Log into the TX54 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the
show ntp
> show ntp
NTP Status Status
-----------------
Status
Sync Status : Up
Remote
Offset
----------------
TX54 User Guide
command at the system prompt:
: Up
Refid
Jitter
-------------
ST
T
When
Poll
Reach
--
-
----
----
-----
Network Time Protocol
Delay
------
-----
601