Alarm Facility Main-Pse Led - Allied Telesis IE220 Series Manual

A M C
LARM ONITORING OMMANDS
-
ALARM FACILITY MAIN PSE LED

alarm facility main-pse led

Overview Use this command to make the fault LED flash if the total power consumed by all
of the PoE devices plugged into the switch exceeds the maximum PoE output
permitted.
Use the no variant of this command to remove this alarm.
Syntax alarm facility main-pse led
no alarm facility main-pse led
Default By default, there are no alarms
Mode Global Configuration
Usage notes You can also use a relay to trigger an external alarm output, such as a buzzer, by
using the command
Example To flash the LED if the total power consumed by all of the PoE devices plugged into
the switch exceeds the maximum PoE output permitted, use the commands:
awplus#
awplus(config)#
To remove that alarm, use the commands:
awplus#
awplus(config)#
Related alarm facility main-pse relay
commands
show alarm facility settings
show alarm facility status
Command Version 5.4.9-1.1: input-member and output-member parameters added on
changes IE510-28GSX switches
C613-50644-01 Rev B
alarm facility main-pse
configure terminal
alarm facility main-pse led
configure terminal
no alarm facility main-pse led
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
relay.
493