Udld Aggressive-Mode - Allied Telesis IE220 Series Manual

U L D
NIDIRECTIONAL INK ETECTION
-
UDLD AGGRESSIVE MODE

udld aggressive-mode

Overview Use this command to set UDLD to aggressive mode on all interfaces.
In normal mode, when the UDLD information times out:
•
•
•
In aggressive mode, when the UDLD information times out:
•
•
Use the no variant of this command to disable aggressive mode on all interfaces.
udld aggressive-mode
Syntax
no udld aggressive-mode
Default Aggressive mode is disabled by default.
Mode Global Configuration
Example To enable aggressive mode on interfaces, use the commands:
awplus#
awplus(config)#
To disable aggressive mode, use the commands:
awplus#
awplus(config)#
Related udld port aggressive-mode
commands
show udld
C613-50644-01 Rev B
(UDLD) C
OMMANDS
No action is taken by UDLD.
The UDLD port state is set to undetermined.
The port behaves according to its STP state.
UDLD tries to re-establish the state of the port.
If not successful, after 8 retries, the port is disabled.
configure terminal
udld aggressive-mode
configure terminal
no udld aggressive-mode
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
725