Table of Contents
Advertisement
L
A
C
INK
GGREGATION
OMMANDS
-
CHANNEL
GROUP
Examples
To add device port1.0.2 to a newly created LACP channel group 2, in active mode,
use the commands below:
awplus#
awplus(config)#
awplus(config-if)#
To remove device port1.0.2 from any created LACP channel groups, use the
command below:
awplus#
awplus(config)#
awplus(config-if)#
To reference channel group 2 as an interface, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
Related
show etherchannel
commands
show etherchannel detail
show etherchannel summary
show port etherchannel
Command
Version 5.4.9-0.1: Ability added to create up to 128 groups as any combination of
changes
static and dynamic channel groups. Also, numbering changed to 1-248.
C613-50644-01 Rev B
configure terminal
interface port1.0.2
channel-group 2 mode active
configure terminal
interface port1.0.2
no channel-group
configure terminal
interface po2
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
737
Advertisement
Table of Contents
