Power Over Ethernet Commands; Introduction - Allied Telesis IE220 Series Manual

20

Introduction

Overview This chapter contains an alphabetical list of commands used to configure Power
over Ethernet (PoE). Each command contains a functional description and shows
examples of configuration and output screens for show commands. These
commands are only supported on PoE capable ports. An error message will display
on the console if you enter a PoE command on a port that does not support PoE.
The following documents offer further information for configuring PoE on
AlliedWare Plus switches.
•
•
•
Power over Ethernet (PoE) is a technology allowing devices such as security
cameras to receive power over LAN cabling.
The Powered Device (PD) referred to throughout this chapter is a PoE or PoE+
powered device, such as an IP phone or a Wireless Access Point (WAP).
AT-IE300-12GP switches support high-power PoE and offer up to 60W of POE on
ports 1.0.9, 1.0.10, 1.0.11 and 1.0.12.
Command List •
•
•
•
•
•
•
C613-50644-01 Rev B
the PoE Feature Overview and
the Support for Allied Telesis Enterprise_MIBs_in AlliedWare
information about which PoE MIB objects are supported.
the SNMP Feature Overview and
SNMP traps.
"clear power-inline counters
"debug power-inline" on page 762
"power-inline allow-legacy" on page 764
"power-inline autoclass" on page 765
"power-inline description" on page 767
"power-inline disconnect-defer" on page 768
"power-inline enable" on page 769
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Power over
Ethernet
Commands
Configuration_Guide.
Configuration_Guide, for information about
interface" on page 761
Plus, for
759