Ipv6 Nd Minimum-Ra-Interval - Allied Telesis IE220 Series Manual

IP 6 C
V OMMANDS
6 - -
IPV ND MINIMUM RA INTERVAL

ipv6 nd minimum-ra-interval

Overview Use this command in Interface Configuration mode to set a minimum Router
Advertisement (RA) interval for an interface.
Use the no variant of this command in Interface Configuration mode to remove the
minimum RA interval for an interface.
Syntax ipv6 nd minimum-ra-interval <seconds>
no ipv6 nd minimum-ra-interval
Default The RA interval for an interface is unset by default.
Mode Interface Configuration for a VLAN interface or a local loopback interface.
Examples To set the minimum RA interval for the VLAN interface vlan2, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
To remove the minimum RA interval for the VLAN interface vlan2, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
Related ipv6 nd ra-interval
commands
ipv6 nd suppress-ra
ipv6 nd prefix
ipv6 nd other-config-flag
C613-50644-01 Rev B
Parameter Description
<seconds>
Specifies the number of seconds between IPv6 Router
Advertisements (RAs). Valid values are from 3 to 1350
seconds.
configure terminal
interface vlan2
configure terminal
interface vlan2
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ipv6 nd minimum-ra-interval 60
no ipv6 nd minimum-ra-interval
915