Table of Contents
Advertisement
VLAN C
OMMANDS
-
PRIVATE
VLAN UFO TRAP
private-vlan ufo trap
Overview
Use this command to enable the sending of SNMP traps for private VLAN UFO.
Use the no variant of this command to disable the sending of SNMP traps for
private VLAN UFO.
Syntax
private-vlan ufo trap
no private-vlan ufo trap
Default
Enabled.
Mode
Global Configuration
Usage notes
This command enables SNMP traps for private-vlan UFO. If enabled, traps will be
sent when any UFO VLAN becomes "isolated", which occurs when traffic can not be
forwarded at Layer 2 because there is no upstream port for the UFO VLAN, and
Layer3 forwarding has not been configured for the VLAN.
Example
To configure a private-vlan UFO trap use the commands:
awplus#
awplus(config)#
Related
private-vlan
commands
snmp-server enable trap
Command
Version 5.4.7-2.1: command added
changes
Version 5.4.8-2.1: added to SBx8100 Series products
Version 5.4.9-0.1: added to x530 Series products
C613-50644-01 Rev B
Parameter
Description
ufo
Specifies private-vlan for those VLANs in UFO mode.
trap
Enables or disables SNMP trap sending for private-vlan UFO.
configure terminal
private-vlan ufo trap
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
595
Advertisement
Table of Contents
