Fiber-Monitoring Action - Allied Telesis IE220 Series Manual

P C C
LUGGABLES AND ABLING OMMANDS
-
FIBER MONITORING ACTION

fiber-monitoring action

Overview Use this command to specify an action to be taken if the optical power received on
the port changes from the baseline by the amount specified in the
fiber-monitoring sensitivity command.
Use the no variant of this command to remove the specified action or all actions
from the port.
fiber-monitoring action [trap] [shutdown] [continuous]
Syntax
no fiber-monitoring action [trap|shutdown]
Default By default a log message is generated, but no additional action is performed.
Mode Interface Configuration mode for a fiber port.
Usage If fiber monitoring is enabled and this command is not used to set an action, a
change in received power on a fiber port only generates a log message.
Example To set the device to send an SNMP trap when port1.0.5 or port1.0.6 receive
reduced power and when that reduced-power alarm is cleared, use the
commands:
awplus(config)#
awplus(config-if)#
To set the device to send an SNMP trap when port1.0.5 or port1.0.6 receive
reduced power, and every polling interval after that until the alarm is cleared, use
the commands:
awplus(config)#
awplus(config-if)#
To set the device to send an SNMP trap and to shut down the port when port1.0.5
or port1.0.6 receive reduced power, use the commands:
awplus(config)#
awplus(config-if)#
C613-50644-01 Rev B
Parameter Description
trap
Send an SNMP notification.
shutdown
Shutdown the port.
continuous
Make the action or actions happen continuously (every polling
interval) while the sensor is in the alarm state. Otherwise, the
action only happens when the alarm is triggered or cleared.
interface port1.0.5-port1.0.6
interface port1.0.5-port1.0.6
interface port1.0.5-port1.0.6
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
fiber-monitoring action trap
fiber-monitoring action trap continuous
fiber-monitoring action trap shutdown
291