Ipv6 Nd Current-Hoplimit - Allied Telesis IE220 Series Manual

IP 6 C
V OMMANDS
6 -
IPV ND CURRENT HOPLIMIT

ipv6 nd current-hoplimit

Overview Use this command to specify the advertised current hop limit used between IPv6
Routers.
Use the no variant of this command to reset the current advertised hop limit to the
default of 0, which means no advertised current hop limit is specified.
Syntax ipv6 nd current-hoplimit <hoplimit>
no ipv6 nd current-hoplimit
Default 0 (No advertised current hop limit specified)
Mode Interface Configuration for a VLAN interface or a local loopback interface.
Examples To set the advertised current hop limit to 2 between IPv6 Routers on vlan2, use the
following commands:
awplus#
awplus(config)#
awplus(config-if)#
To reset the advertised current hop limit to the default 0 on vlan2, use the
following commands:
awplus#
awplus(config)#
awplus(config-if)#
Related ipv6 nd managed-config-flag
commands
ipv6 nd prefix
ipv6 nd suppress-ra
C613-50644-01 Rev B
Parameter Description
<hoplimit>
Specifies the advertised current hop limit value.
Valid values are from 0 to 255 hops.
configure terminal
interface vlan2
configure terminal
interface vlan2
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ipv6 nd current-hoplimit 2
no ipv6 nd current-hoplimit
911