Table of Contents
Advertisement
A
M
C
LARM
ONITORING
OMMANDS
SHOW ALARM FACILITY SETTINGS
show alarm facility settings
Overview
Use this command to see whether an LED flashes or a relay is turned on if a certain
alarm occurs. The output also includes the alarm position for each contact input.
show alarm facility settings
Syntax
Mode
User Exec and Privileged Exec
Example
To display all the alarm settings on a switch, use the following command:
awplus#
Output
Figure 14-1: Example output from show alarm facility settings
Related
show alarm facility status
commands
Command
Version 5.4.9-1.1: command syntax changed from show alarm settings to show
changes
alarm facility settings
C613-50644-01 Rev B
show alarm facility settings
awplus#show alarm facility settings
Global alarms:
Alarm
-----------------------------------------------------------------
EPSR
Loop detect
G8032
UFO
Per stack member alarms:
Alarm
-----------------------------------------------------------------
External PSU
External PSU
External contact input
Link down
Link down
Link down
Link down
...
Temperature
Alarm
---------------------------------------------------
External contact input
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ID
Outputs - L: LED, R: Relay
-
-
-
-
-
-
-
-
ID
Outputs - L: LED, R: Relay
1
L
2
L
1
-
port1.0.1
R1
port1.0.2
-
port1.0.3
-
port1.0.4
-
-
-
ID
Alarm position
1
Open
505
Advertisement
Table of Contents
