Table of Contents
Advertisement
P
E
C
OWER OVER
THERNET
OMMANDS
-
SHOW POWER
INLINE
Table 1: Parameters in the show power-inline command output (cont.)
C613-50644-01 Rev B
Parameter
Admin
Pri
Oper
Power
Device
Class
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
The administrative state of PoE on a PoE port, either
Enabled or Disabled.
The current PoE priorities for PoE ports, as configured using
the
power-inline priority
• Low is the lowest priority (this is the default).
• High is the second highest priority.
• Crit (critical) is the highest priority.
If the switch cannot supply all ports, it will supply critical
ports, then high-priority ports, then low-priority ports.
The current PoE port state when this command was issued:
• Powered displays if there is a PD connected and power
is being supplied.
• Denied displays if supplying power would make the
switch go over the power budget. It also displays if the
switch is overheating and therefore has stopped
supplying power to the port.
• Off displays if the port is not supplying power but has
not been denied power by the switch. This is the default
state for ports that are not connected to a PD.
• Disabled displays if the PoE port is administratively
disabled.
• Syncing displays if PoE is still initializing the port when
you issue the command.
• Fault displays if there is a problem with PoE on the port.
• Unknown displays if PoE cannot determine the state of
the port.
The power consumption in milliwatts (mW) for the PoE
port when this command was entered.
The description of the connected PD device if a description
has been added with the
command. No description is shown for PDs not configured
with the
power-inline description
The class of the connected PD, if power is being supplied to
the PD.
command:
power-inline description
command.
783
Advertisement
Table of Contents
