Show Platform - Allied Telesis IE220 Series Manual

Industrial ethernet layer 2+ switches, command reference for alliedware plus version 5.5.3-0.x
Table of Contents

Advertisement

S
C
WITCHING
OMMANDS

SHOW PLATFORM

show platform
Overview
This command displays the settings configured by using the platform commands.
show platform
Syntax
Mode
Privileged Exec
Usage notes
This command displays the settings in the running config. For changes in some of
these settings to take effect, the device must be rebooted with the new settings in
the startup config.
Example
To check the settings configured with platform commands on the device, use the
following command:
awplus#
Output
Figure 15-7: Example output from the show platform command:
Table 16: Parameters in the output of the show platform command. Note that the parameters
displayed depend on your device, and that not all displayed parameters can be modified on
all devices.
Parameter
Routing Ratio
Route Weighting
MAC vlan hashing
algorithm
L3 hashing algorithm
Load Balancing
C613-50644-01 Rev B
show platform
awplus# show platform
MAC vlan hashing algorithm
L3 hashing algorithm
Load Balancing
stop-unreg-mc-flooding
Vlan-stacking TPID
Hardware Filter Size
Description
Whether all memory is allocated to IPv4 address table entries only, or whether it is
allocated evenly to both IPv4 and IPv6 addresses (set with the platform
routingratio command).
The split between multicast and unicast route entries (set with the platform
routingratio command).
The MAC VLAN hash-key-generating algorithm (set with the platform
mac-vlan-hashing-algorithm command). The default algorithm is crc32l. The
algorithm may need to be changed in rare circumstances in which hash collisions
occur.
The L3 VLAN hash-key-generating algorithm (set with the platform
l3-vlan-hashing-algorithm command). The default algorithm is crc32l. The
algorithm may need to be changed in rare circumstances in which hash collisions
occur.
Which packet fields are used in the channel load balancing algorithm (set with the
platform load-balancing command).
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
crc32l
crc32l
src-dst-ip
off
0x8100
ipv4-limited-ipv6
557

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ie220-6ghxIe220-10ghx

Table of Contents