Allied Telesis IE220 Series Manual page 789

P E C
OWER OVER THERNET OMMANDS
-
SHOW POWER INLINE INTERFACE
Table 3: Parameters in show power-inline interface output (cont.)
Related show power-inline
commands
show power-inline interface detail
Command Version 5.4.8-0.2: added to x550 series products
changes
C613-50644-01 Rev B
Parameter Description
Max (mW)
The power in milliwatts (mW) allocated for the PoE port.
Additionally, note the following is displayed per PoE port:
• [U] if the power limit for a port was user configured (with the
• [L] if the power limit for a port was supplied by LLDP.
• [C] if the power limit for a port was supplied by the PD class.
HANP
Whether High Availability Network Power is enabled (on) or not
(off) on the port. HANP is also known as Continuous PoE. It
enables the switch to perform actions such as software
upgrades without forcing the Powered Devices to power cycle.
This allows, for example, IP cameras to buffer data instead of
losing it. This column only displays if Continuous PoE has been
enabled globally on the switch.
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
power-inline max command).
789