Log Permanent (Filter) - Allied Telesis IE220 Series Manual

L C
OGGING OMMANDS
( )
LOG PERMANENT FILTER

log permanent (filter)

Overview This command creates a filter to select messages to be sent to the permanent log.
Selection can be based on the priority/ severity of the message, the program that
generated the message, the logging facility used, a sub-string within the message
or a combination of some or all of these.
The no variant of this command removes the corresponding filter, so that the
specified messages are no longer sent to the permanent log.
log permanent [level <level>] [program <program-name>]
Syntax
[facility <facility>] [msgtext <text-string>]
no log permanent [level <level>] [program <program-name>]
[facility <facility>] [msgtext <text-string>]
Parameter Description
level
Filter messages sent to the permanent log by severity level.
<level>
The minimum severity of message to send. The level can be specified as one of the following
numbers or level names, where 0 is the highest severity and 7 is the lowest severity:
0|emergencies
1|alerts
2|critical
3|errors
4|warnings
5|notices
6|informational
7|debugging
program
Filter messages by program. Include messages from a specified program.
<program-
The name of a program to log messages from. You can enter either one of the following
name>
predefined program names (depending on your device model), or another program name
that you find in the log output. The pre-defined names are not case sensitive but other
program names from the log output are.
rip
ripng
ospf
ospfv3
bgp
rsvp
pim-dm
pim-sm
C613-50644-01 Rev B
System is unusable
Action must be taken immediately
Critical conditions
Error conditions
Warning conditions
Normal, but significant, conditions
Informational messages
Debug-level messages
Routing Information Protocol (RIP)
Routing Information Protocol - next generation (RIPng)
Open Shortest Path First (OSPF)
Open Shortest Path First (OSPF) version 3 (OSPFv3)
Border Gateway Protocol (BGP)
Resource Reservation Protocol (RSVP)
Protocol Independent Multicast - Dense Mode (PIM-DM)
Protocol Independent Multicast - Sparse Mode (PIM-SM)
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
433