Power-Inline Allow-Legacy - Allied Telesis IE220 Series Manual

P E C
OWER OVER THERNET OMMANDS
- -
POWER INLINE ALLOW LEGACY

power-inline allow-legacy

Overview This command enables detection of pre-IEEE 802.3af Power Ethernet standard
legacy powered devices (PDs).
The no variant of this command disables detection of pre-IEEE 802.3af Power
Ethernet standard legacy powered devices.
Syntax power-inline allow-legacy
no power-inline allow-legacy
Default Detection of legacy PDs is disabled on all ports
Mode Global Configuration
Examples To enable detection of legacy PDs, use the following commands:
awplus#
awplus(config)#
To disable detection of legacy PDs, use the following commands:
awplus#
awplus(config)#
Validation show power-inline
Commands
show running-config
Command Version 5.4.8-0.2: added to x550 series products
changes
Version 5.4.9-0.1: default changed to "disabled"
C613-50644-01 Rev B
configure terminal
power-inline allow-legacy
configure terminal
no power-inline allow-legacy
power-inline
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
764